Managing Magazine Locations - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.4 ShopMill tool management
Option P

5.4.10 Managing magazine locations

Magazine
Disabling a magazine
location
Tool status
Enabling a magazine
location
5-160
-or-
Select the option "P" in the third field of the last column if you want to
assign the tool to a fixed magazine location.
The set tool properties are immediately active.
The magazine locations are listed with their tools, magazine locations
are indicated as disabled/not disabled, and the properties assigned to
the active tool (e.g. oversize) are displayed in the magazine list.
Operating sequence
Select the "Magazine" softkey.
Magazine locations can be reserved or disabled for specific tools, e.g.
in the case of an oversized tool.
Selecting the required magazine location.
Toggle in column "Disable location" with the softkey "Alternative" until
a "G" (= disabled) appears in the field in question. The location is now
disabled. A tool can no longer be loaded into this magazine location.
In the "Tool status" column you can see which properties have been
assigned to the active tool:
•
G: Tool is disabled
•
U: Tool oversized
•
P: Tool at a fixed location
Position the cursor on the disabled field.
Deselect option G in the "Location disable" column.
The magazine location is enabled again.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved