Make Active Tool Offset Operative Immediately - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.2 Tool offset

5.2.12 Make active tool offset operative immediately

Machine manufacturer
References
5-140
Function
The machine data can be set to specify that the active tool offset can
be activated immediately if the part program switches to the "Reset"
or "Stop" state.
Further information
When the function is used in the Reset state, the machine data must
be set such that the offset is not reset when the program switches to
Reset.
Please note information supplied by machine tool manufacturer!
/FB1/K2: Axes/Coordinate Systems etc.
Caution
The offset is applied in the next programmed axis motion in the part
program after "Cycle Start" in Reset.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved