Makita 2414EN Instruction Manual page 6

Setting for desired cutting angle
1
013132
To change the cutting angle, follow the procedure
below:
1. Loosen the two hex bolts.
2. Set the guide plate to the desired angle (0° - 45°).
3. For more accurate angle, use a protractor or
triangle ruler. Keep the handle down so that the
cut-off wheel extends into the base. At the same
time, adjust the angle between the guide plate
and the cut-off wheel with a protractor or triangle
ruler.
4. Tighten the hex bolts securely. At this time, make
sure that the guide rule does not move.
5. Check the angle again.
CAUTION:
Never perform miter cuts when the guide plate is
•
set at the 35 - 205 mm or 70 - 240 mm position.
NOTE:
The scale on the guide plate is only a rough
•
indication.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Removing or installing cut-off wheel
2
013182
1. Socket wrench
2. Guide plate
2
3. Hex bolts
3
1. Clamping screw
2. Safety guide
1
013148
013147
To remove the wheel, loosen the clamping screw, hold
the safety guide by both hands and raise it, then slide
the safety guide towards yourself.
1
013146
Press the shaft lock so that the wheel cannot revolve
and use the socket wrench to loosen the hex bolt by
turning it counterclockwise. Then remove the hex bolt,
outer flange and wheel. (Note: Do not remove the inner
flange, ring and O-ring.)
To install the wheel, follow the removal procedures in
reverse.
1
2
3
4
003762
CAUTION:
Be sure to tighten the hex bolt securely.
•
Insufficient tightening of the hex bolt may result in
severe injury. Use the socket wrench provided to
help assure proper tightening.
6
1. Shaft lock
2. Socket wrench
2
1. O-ring
7
2. Inner flange
3. Ring
4. Spindle
5. Cut-off wheel
6. Outer flange
7. Hex bolt
6
5