Specifications - Makita 2414EN Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Wheel diameter
No load speed (min
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model
Hole diameter
-1
)
With under cover
With European type safety
guard and under cover
Safety class
with household
equipment
environmentally compatible
END202-6
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.21 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
waste
Noise
The typical
according to EN61029:
Sound pressure level (L
and its
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
ENE007-3
The vibration
determined according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
ENF002-2
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
2
2414EN
355 mm
25.4 mm
3,800
500 mm x 280 mm x 620 mm
17.6 kg
/II
A-weighted noise
) : 102 dB(A)
pA
) : 112 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 3.5 m/s
h
2
ENF100-1
ENG905-1
level determined
ENG900-1
vector sum)
2
ENG901-1