Advertisement
Operation
Turn the tool on and wait until the blade
attains full speed. Then rest the base flat
on the workpiece and gently move the tool
forward along the previously marked cut-
ting line. When cutting curves, advance the
tool very slowly.
I
.
I
CAUTION
:
Failure to hold the tool base flush with the workpiece may cause blade breakage.
Bevel cutting
With the base tilted, you can make bevel
cuts
a t
any angle between 0" and 45" (left
or right).
Loosen the bolt on the back of the base
with the hex wrench and slide the base
backwards. Tilt the base to the desired
angle. The edge of the housing indicates
the bevel angle.
Then check the contact between the back
edge of the blade and the roller.
Now tighten the bolt securely on the back
of the base.
Edge of housing
9
Advertisement
