Table of Contents
Advertisement
Installation
instructions
INSTALLATION-VENTEDTO THE OUTSIDE
i-9-1 INSTALL DUCT COVERS
. Place the decorative
duct
.__
covers on top of the hood. Plounting_
NOTE: The inside (upper)
screws
I
J
duct piece has holes on one
J:_,_ j
end. The holes are intended
for use when the hood is
installed for recirculating
purposes. Slide the inside end
into the outer piece; the vent
!._
j
holes should not be visible in
this installation.
The inside duct piece must slip into the folded ends
of the outer section.
Upper
duct cover
Duct cover
support bracket
Duct cover
support bracket
Lower
duct cove_.
_,.
Lower duct %-_'_
.A
cover seat
, Extend the inner duct upward to the ceiling
bracket.
. Secure duct cover to ceiling bracket with 2 screws.
INSTALL FILTERS
IMPORTANT: Check to be sure that the main ON/
OFF switch next to the motor is in the ON position.
, Remove protective
film on the filters.
Filter Lock
NOTE: The charcoal filter is not required for this
installation.
, Tip the filter into the left or right side of the
opening. Lift the filter to the opposite side and
into the filter lock.
. To remove the filter, pull the filter lock downward.
[-_ FINALIZE INSTALLATION
, Check to be sure all tape and packaging
materials
have been removed.
, Refer to the Owner's Manual for operating
instructions.
14
Advertisement
Table of Contents
