Makita 3612 Instruction Manual page 10

1
2
3
4
5
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting screw
4. Wing bolt (B)
5. Straight guide
1
2
55 mm
( 2 - 3/16" )
55 mm
3
( 2 - 3/16" )
1. More than 15mm (5/8")
2. Straight guide
3. Wood
10
Straight guide (optional accessory)
003677
The straight guide is effectively used for straight cuts when
chamfering or grooving.
Install the straight guide on the guide holder with the wing
003683
bolt (B). Insert the guide holder into the holes in the tool base
and tighten the wing bolt (A). To adjust the distance between
the bit and the straight guide, loosen the wing bolt (B) and
turn the fine adjusting screw (1.5 mm or about 1/16" per
turn). At the desired distance, tighten the wing bolt (B) to
secure the straight guide in place.
Wider straight guide of desired dimensions may be made by
003684
using the convenient holes in the guide to bolt on extra
pieces of wood.
When using a large diameter bit, attach pieces of wood to
the straight guide which have a thickness of more than
15 mm (5/8") to prevent the bit from striking the straight
guide.
When cutting, move the tool with the straight guide flush with
the side of the workpiece.
Templet guide (optional accessory)
003688
The templet guide provides a sleeve through which the bit
passes, allowing use of the tool with templet patterns.