Makita 3606 Instruction Manual page 9

1
3
1. Base plate
2. Templet guide
3. Screw
1
2
3
4
5
6
1. Bit
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside diameter of the templet
guide
7. Templet guide
Templet guide (optional accessory)
003687
The templet guide provides a sleeve through which the bit
passes, allowing use of the tool with templet patterns.
To install the templet guide, loosen the screws on the tool
003691
base, insert the templet guide and then tighten the screws.
2
Secure the templet to the workpiece. Place the tool on the
003695
templet and move the tool with the templet guide sliding
7
along the side of the templet.
NOTE:
• The workpiece will be cut a slightly different size from the
templet. Allow for the distance (X) between the bit and
the outside of the templet guide. The distance (X) can be
calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide –
bit diameter) / 2
Trimmer guide (optional accessory)
003697
Trimming, curved cuts in veneers for furniture and the like
can be done easily with the trimmer guide. The guide roller
rides the curve and assures a fine cut.
9