Operation; Maintenance; Driving Operation; Replacing Carbon Brushes - Makita 6833 Instruction Manual

OPERATION

2
15mm(5/8")
1. Stopper base
2. Wall

MAINTENANCE

1. Limit mark
10

Driving operation

002676
Switch on the tool by pressing the switch trigger and at the
same time pushing the lock button. Hold the tool squarely
against the workpiece and apply forward pressure to the tool.
The screw will be automatically carried to the driving position
and driven into the workpiece.
NOTE:
• Do not fire the tool without screws. This will damage the
workpiece.
• If the feeder box becomes sluggish in operation, spray
car wax (spray type wax) on its sliding surfaces. Never
lubricate it.
Driving in corner
001887
This tool can be used to drive at a position 15 mm (5/8")
away from the wall as shown in the figure.
1
CAUTION:
• Driving at a position closer than 15 mm (5/8") to the wall
or driving with the stopper base in contact with the wall
may damage the screw heads and cause wear on the
bit. This may also lead to poor fastening of screws and
malfunction of the tool.
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1