Advertisement
Insert the outer and inner
sleeves
into the tool while rotating the inner sleeve alternately
clockwise and counterclockwise until there i s no gap between the outer sleeve and the
tool.
See the figure below. Then tighten the two screws securely.
Switch action
To start
the
tool, simply pull the trigger. Release the trigger to stop.
C A U T I O N
:
Before plugging in the tool, always check
to see
that the trigger switch actuates proper-
ly and returns to the "OFF" position when released.
Bolt installation
Slip the tool onto the bolt
so
that the inner
sleeve
completely covers the bolt tip.
CAUTION :
Be
careful when fitting the
sleeve
onto the
bolt tip.
Striking the tip can damage i t
so
that it will no longer fit inside the sleeve
properly.
Keep forward pressure on the tool while
sliding
it
further forward until the outer
sleeve
fits completely over the nut. I f the
tool fails to fit completely over the nut,
twist the tool slightly right and left while
pushing forward.
sleeve
Pull the trigger switch. The outer
sleeve
turns to begin tightening the nut.
6
Advertisement
