Makita DA4000LR Instruction Manual page 8

1
1. High
2. Low
1
1. Chuck key
2. Drill chuck
8
Use of it with angle attachment
003044
Screw the side grip for the angle attachment on the angle
housing. Then tighten the side grip by turning clockwise at
the desired position.
Use of it without angle attachment
003045
Screw the side grip on the tool barrel securely. The side grip
can be installed on either side of the tool, whichever is con-
venient.
Installing or removing angle attachment
003066
The angle head has a spindle on each end. For higher speed
operation, attach the drill chuck to the end marked "HIGH".
The higher speed is better suited for drilling smaller diameter
holes.
For lower speed operation, attach the drill chuck to the end
marked "LOW". The lower speed is best utilized for drilling
2
larger diameter holes.
The tool is factory assembled with the chuck on spindle end
003067
marked "HIGH". To change to the "LOW" speed, proceed as
follows:
To remove the drill chuck, first open the chuck jaws com-
pletely and place the chuck key in one of the key holes.
2