Test Procedures
Set up for Analog call
Set up for Analog call
Figure 24. Call Control Screen
Display
Data / Meas
Phone : 111-111-1111
Active
ESN (dec) : 156-4460397
ESN (hex) : 9C440F6D
Register
SCM : Class IV, Continuous, 25 MHz
Page
Access
Connect
System Type
Active
DCCH
Register
Page
Cntrl Chan
Handoff
334
Release
Amplitude
Order
-50.0
Chng PL 0
dBm
SID
MS Id
231
Phone Num
1111111111
Registration
1.
Put the Test Set in Active state
by selecting Active from the list on the
left side of the screen.
2.
Select Data from the Data/Meas
field. This is the default mode.
3.
Select Register from the list to
register phone.
4.
If the registration message has
been received, the Test Set will display
registration data in the upper half of the
screen as shown in the sample screen
above.
Page
1
Select page from the list on the left
side of the screen.
2
If the mobile responds, you will
see the Access annunciator light briefly.
3
Answer the call by raising the flip
38
CALL CONTROL
Traffic Chan Assisgnment
Chan : -
212
Pwr Lvl : -
0
5970Hz
SAT :
Motorola Confidential Proprietary
Select CALL CNTL from the To Screen
Select System type: AMPS
•
Zero the RF Power meter in the:
•
Call Config Screen
Set Amplitude to: -50 dBm
•
To Screen
Set SID: Your phone' s System
•
ID
CALL CNTL
Select: Active
•
CALL CNFG
ANLG MEAS
Voice Channel Assignment
•
SPEC ANL
DIG MEAS
Type:
Chan: 212
•
Pwr Lvl: 4
•
More
SAT: 5970Hz
•
or press SEND on the mobile to start the
conversation.
4
The Connect annunciator lights.
This is the Connect state.
Origination
1
Dial the desired phone number on
the mobile station and press SEND.
2
The Access annunciator will light
while the Test Set signals the mobile on
the assigned voice channel.
3
The connect annunciator will light
if the mobile properly signals the Test
Set.
TDMA T2290/T2297