Advertisement
11. Causes and Operator Prevention of Kickback:
Kickback is a sudden reaction to a pinched, bound or misaligned saw blade,
causing an uncontrolled saw to lift up and out of the workpiece toward the
opera tor.
When the blade is pinched or bound tightly by the kerf closing down, the blade
stalls and the motor reaction drives the unit rapidly back toward the operator.
If the blade becomes twisted or misaligned in the cut, the teeth at the back
edge of the blade can dig into the top surface of the wood causing the blade
to climb out of the kerf and
jump
back toward
operator.
Kickback is the result of tool misuse and/or incorrect operating procedures
or conditions and can be avoided by taking proper precautions as given below.
Maintain a firm grip with both hands on the saw and position your body and
arm t o allow you t o resist KICKBACK forces. KICKBACK forces can be
controlled by the operator, if proper precautions are taken.
When blade is binding, or when interrupting a cut for any reason, release
the trigger and hold the saw motionless in the material until the blade comes
t o a complete stop. Never attempt t o remove the saw from the work or pull
the saw backward while the blade is in motion or KICKBACK may occur.
Investigate and take corrective actions t o eliminate the cause of blade binding.
When restarting a saw
in
the workpiece, center the saw blade in the kerf
and check that saw teeth are not engaged into the material. If saw blade
is binding, it may walk up or KICKBACK from the workpiece as the saw is
restarted.
Support large panels t o minimize the risk of blade pinching and KICKBACK.
Large panels tend t o sag under their o w n weight. Supports must be placed
under the panel on both sides, near the line of cut and near the edge of the
panel as shown in Fig. 1.
To minimize the risk of blade pinching and kickback. When cutting operation
requires the resting of the saw on the work piece, the saw shall be rested
on the laraer Dortion and the smaller
To avoid kickback do support board
or
panel near the cut.
Fig.
'
ece cut off.
Don't support board
or
panel away
from the cut.
Fig.
:
5
Advertisement
