Advertisement
0
When you charge a new battery cartridge or a battery cartridge which has
not
been used
for a long period, it may not accept a full charge.
This is
a normal condition and
does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it almost completely a couple of times.
If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Installing or removing driver bit or drill bit
CAUTION
:
Always be sure that the tool i s switched off and the battery cartridge i s removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
Switch action
Move the reversing switch lever to the
"FWD" position for clockwise rotation or
the
"REV"
position for counterclockwise.
To start the tool, simply pull the trigger.
Release the trigger to stop. When the re-
versing switch lever
is
in the neutral posi-
tion, the tool will not start even if you pull
the trigger.
CAUTION :
Before inserting the battery cartridge into the tool, always check to
see
that the trigger
0
Always check the direction of rotation before drilling.
0
Use the reversing switch lever only when the tool comes to a complete stop. Changing
When not operating the tool, keep the reversing switch lever in the neutral position.
switch actuates properly and returns t o the
"OFF"
Position when released.
the direction of rotation before the tool stops may ruin the tool.
7
Advertisement
