Advertisement
Adjusting fastening torque
4.5 ( 1 1/64',)
4.8 13/16")
5.1 113164'1
5.5 17/32',)
The fastening torque can be adjusted in six
stages by turning the adjusting ring so that
the pointer on the adjusting ring points t o
a number on the tool body. The fastening
torque is minimum when the pointer points
t o the number
1
and maximum when it
points to the
marking. The clutch
will slip a t varying torque levels when the
pointer is set a t the numbers 1 to
5.
The
clutch is designed not to slip
a t
the
*\-
marking.
2.9
-
3.2 17/64'
-
118'7
3.1
-
3.4 (1/8"
-
9/64")
3.3
-
3.6 (1/8"
-
9/64"]
3.7
-
3.9 19/64"
-
5/32',)
Before actual operation, drive a trial screw into your material or
a
piece of duplicate
material t o determine which torque level i s required for a particular application.
NOTE :
The adjusting ring cannot be locked with ihe pointer positioned half-way between the
numbers.
Screwdriving operation
Place the point of the driver bit in the
screw head and apply pressure t o the tool.
Start the tool slowly and then increase the
speed gradually. Release the trigger as soon
as the clutch cuts in.
NOTE :
0
Make sure that the driver bit is inserted straight in the screw head, or the screw and/or
bit may be damaged.
*When driving wood screws, predrill pilot
holes to make driving easier and t o pre-
vent splitting of the workpiece. See the
chart.
5.8 17/32")
6.1 ( 1 5 / 6 4 ' )
I
4.0
-
4.2 (5132''
-
11/64',)
I
4.2
-
4.4 (11/64"
-
11/64")
10
Advertisement
