Advertisement
Installing or removing driver bit
CAUTION :
When installing or removing the bit, be careful not to touch the trigger switch.
To
install the bit, place it in the chuck as far as
it will go. Tighten the chuck by hand. Place
the chuck key in each of the three holes and
tighten clockwise.
Be sure to tighten all three chuck holes
evenly.
To remove the bit, turn the chuck key coun-
terclockwise in just one hole, then loosen the
chuck by hand.
1
Chuck key
Switch action
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger to stop.
7
Advertisement
