Kenwood BL710 series Instructions Manual page 6

before using for the first time
Wash the parts: see 'care and
cleaning'.
key
blender
filler cap
lid
goblet
sealing ring
blade unit
base
cord storage
speed + pulse control
power unit
vents
mill (if supplied)
mill jar
mill lid
to use your blender
1 Fit the sealing ring
unit - ensuring the seal is located
correctly in the grooved area.
Leaking will occur if the seal
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened. Refer to
the graphics on the underside of the
blade unit as follows:
- unlocked position
- locked position
4 Put your ingredients into the goblet.
5 Fit the filler cap to the lid and push
down to secure.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit.
The appliance won't work if
the blender is incorrectly
fitted.
8 Plug in and select a speed (refer to
the recommended speed chart).
Select speed 1 (low) to 5 (High) by
turning the speed control. At the end
of blending return the speed control
to "0" before removing the blender.
into the blade
into the base
(P) Pulse – operates the motor in a
start/stop action. The pulse will
operate for as long as it is held in
position.
hints
To blend dry ingredients - cut into
pieces, remove the filler cap, then
with the machine running, drop the
pieces down one by one. Keep your
hand over the opening. For best
results empty regularly.
The processing of spices is not
recommended as they may damage
the plastic parts.
When making mayonnaise, put all
the ingredients, except the oil, into
the blender. Remove the filler cap.
Then, with the appliance running,
add the oil slowly through the hole in
the lid.
Thick mixtures, e.g. pâtés and dips,
may need scraping down. If the
mixture is difficult to process, add
more liquid.
to use your mill
1 Put your ingredients into the jar. Fill it
no more than half full.
2 Fit the sealing ring
unit - ensuring the seal is located
correctly in the grooved area.
Leaking will occur if the seal
is damaged or incorrectly
fitted.
3 Clip the blade unit
.
4 Turn the mill blade assembly upside
down. Lower it into the jar
blades down. Turn in a clockwise
direction to lock.
5 Place the mill onto the power unit.
6 Select a speed or use the pulse
control (refer to the recommended
speed chart).
7 After milling, you can replace the
blade assembly with the mill lid
6
(if supplied)
into the blade
into the base
,
.