1. Manuals
  2. Brands
  3. Black & Decker Manuals
  4. Saw
  5. BDEL701
  6. Manual

Black & Decker BDEL701 Manual

Chop saw
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
BDEL701
English
3

Advertisement

Table of Contents
loading

Related Manuals for Black & Decker BDEL701

Summary of Contents for Black & Decker BDEL701

  • Page 1 BDEL701 English...
  • Page 2 DIAMETER OF WORK PIECE FIG.1 FIG.2 SPACE BLOCK WIDTH OF SPACE BLOCK FIG.3 CUT-OFF END BLOCK FIG.4 FIG.5 FORWARD FIG.8 FIG.7 FIG.6 FIG.9 .3" (8mm)

  • Page 3: Technical Data

    ENGLISH f. If operating a power tool in a damp location is BDEL701 unavoidable, use a residual current device 2100W Chop Saw (RCD)protected supply.Use of an RCD reduces the risk of electric shock. TECHNICAL DATA NOTE: The term "Residual Curent Device (RCD)" can be BDEL701 replaced by "Ground Fault Circuit Interrupter (GFCI)"...

  • Page 4: Warning Symbols

    ENGLISH • Use chop saw in a well-ventilated area. operate the power tool. Power tools are dangerous • Turn chop saw off before removing any pieces from the in the hands of untrained users. e. Maintain power tools. Check for misalignment or base.

  • Page 5: Electrical Safety

    ENGLISH IRREGULARLY SHAPED OBJECTS MAY REQUIRE .......Use Ear Protection ADDITIONAL HOLDING MEANS IF THEY CANNOT BE V .......Volts HELD SECURELY IN VISE. A .......Amperes CAUTION: DO NOT CUT MAGNESIUM WITH THIS TOOL. Hz .......Hertz W .......Watts Maximum Cutting Capacity min.......minutes NOTE: Capacity shown on chart assumes no wheel wear .......Alternating current and optimum fence position.
  • Page 6 ENGLISH CAUTION: When changing to a new wheel, readjust making these cuts. To Change Spacing between The Fence and Vise depth stop to original position to prevent cutting intosupporting surface. Using the wrench provided, loosen and remove the two fence bolts (P). Adjust the fence (E) to desired locations.Insert both fence bolts in provided locations.

  • Page 7: Maintenance

    ENGLISH MAINTENANCE NOTE: Unit may be converted to a 3-wire twist lock cord set at an authorized service center. Your Black & Decker power tool has been designed to operate over a long period of time with a minimum of maintenance.Continuous satisfactory operation depends ACCESSORIES upon proper tool care and regular cleaning.Your tool is not...

Table of Contents