Cleaning; Deck Washout Port - Craftsman 917.203920 Operator's Manual

CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Clean debrisfrom steering plate. Debris
can restrict clutch/brake pedal shaft move-
ment, causing belt slip and loss of drive.
A CAUTION: Avoid all pinch points and
movable parts
Steering System, Dash, Fender
and Mower Not Shown
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with automotive
type wax.
Except for the washout port (if equipped),
we do not recommend using a garden hose
or pressure washer to clean the outside of
your tractor unless the engine and transmis-
sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass, leaves
and trash from outside tractor and mower.
DECK WASHOUT PORT
Your tractor's deck is equipped with a washout
port as part of its deck wash system. It should
be utilized after each use.
1. Drive the tractor to a level, clear spot on
your lawn, near enough to a water spigot
for your garden hose to reach.
IMPORTANT-" Make certain the tractor's
discharge chute is directed AWAY from your
house, garage, parked cars, etc. Remove bag-
ger chute or mulch cover if attached.
2. Make sure the attachment clutch control
is in the "DISENGAGED" position, set
the parking brake, and stop the engine.
3. Threadthe nozzle adapter (packaged with
your tractor's Operator's Manual) onto the
end of your garden hose.
4. Pull back the lock collar of the nozzle
adapter and push the adapter onto the
deck washout port at the left end of the
mower deck. Release the lock collar to
lock the adapter on the nozzle.
Nozzle _.iHose
Adapter __,_ Washout Port
IMPORTANT: Tug hose ensuring connection
is secure.
5. Turn the water on.
6. While sitting in the operator's position on
the tractor, re-start the engine and place
the throttle lever in the Fast ",_" position.
IMPORTANT: Recheck the area to ensure the
area is clear. Ensure no children are in the area
while cleaning the deck.
7. Move the tractor's attachment clutch con-
trol to the "ENGAGED" position. Remain
in the operator's position with the cutting
deck engaged until the deck is cleaned.
8. Move the tractor's attachment clutch con-
trol to the "DISENGAGED" position. Turn
the ignition keyto the STOP position to turn
the tractor's engine off. Turn the water off.
9. Pull back the lock collar of the nozzle
adapter to disconnect the adapter from
the nozzle washout port.
10. Move the tractor to a dry area, preferably
a concrete or paved area. Place the at-
tachment clutch control in the"ENGAG ED"
position to remove excess water and to
,_ help dry before putting the tractor away.
WARNING: A broken or missing washout
fitting could expose you or others to thrown
objects from contact with the blade.
• Replace broken or missing washout fitting
immediately, prior to using mower again.
• Plug any holes in mower with bolts and
Iocknuts.
20