Canon PIXMA iP6220D Service Manual page 26

Destination settings
Button and LCD test
Note: At the end of the service mode, press the Power button.
<Service mode operation procedures>
1) With the machine power turned off, while pressing the Stop/Reset button, press and hold the Power button. (DO
NOT release the buttons. The Power LED lights in green to indicate that a function is selectable.)
2) While holding the Power button, release the Stop/Reset button. (DO NOT release the Power button.)
3) While holding the Power button, press the Stop/Reset button 2 times, and then release both the Power and
Stop/Reset buttons. (Each time the Stop/Reset button is pressed, the Alarm and Power LEDs light alternately,
Alarm in orange and Power in green, starting with Alarm LED.)
4) When the Power LED lights in green, press the Stop/Reset button the specified number of time(s) according to
the function listed in the table below. (Each time the Stop/Reset button is pressed, the Alarm and Power LEDs
light alternately, Alarm in orange and Power in green, starting with Alarm LED.)
Time(s) LED indication
0 times Green (Power)
1 time Orange (Alarm) Service test print
2 times Green (Power)
3 times Orange (Alarm) EEPROM initialization
4 times Green (Power)
5 times Orange (Alarm) Destination settings
6 times Green (Power)
11 times Orange (Alarm) Button and LCD test
12 times or
more
5) After the function (menu) is selected, press the Power button. The Power LED lights in green, and the selected
function is performed. (When the operation completes, the machine returns to the menu selection mode
automatically.)
See "Service mode operation
procedures" below.
See "Service mode operation
procedures" below.
Function
Power off
EEPROM information
print
Waste ink counter
resetting
Print head deep
cleaning
Return to the menu
selection
1-20
unit).
If the platen waste ink amount is 7% or
more, replace the platen ink absorber
(inside the bottom case unit).
After destination settings, make sure to
initialize the EEPROM.
Confirm the button and LCD operation.
Perform this test at operation panel
replacement.
Remarks
See 3-4. Verification Items, (1) Service test
print.
See 3-4. Verification Items, (2) EEPROM
information print.
Proceed to the following step 5), and follow
the Waste ink counter reset procedures.
Proceed to the following step 5), and follow
the Destination settings procedures.
Proceed to the following step 5), and follow
the Button and LCD test procedures.