Black & Decker BDCIM18 User Manual page 6

Additional safety instructions for batteries and
chargers (Not provided with the tool)
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C
u
and 40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions
u p
given in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your BLACK+DECKER charger only to charge
u
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
6
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Chuck collar
4. Quick release chuck
5. LED Work light
6. Bit holder
7. Charger (not included, sold separately)
8. Battery (not included, sold separately)
9. Battery release button
Assembly
Warning! Before assembly, remove the battery from the
tool.
T
u
the tool. Slide the battery into the receptacle and push
until the battery snaps into place.
To remove the battery (8), push the battery release
u
button (9) while at the same time pulling the battery
out of the receptacle.
Fitting and removing a drill bit or screwdriver
easy exchange of bits.
Fitting a drill bit or screwdriver bit
Grasp the chuck collar (3) and pull away from the front
u
of the tool.
Insert the bit shaft (10) and release the chuck collar
u
(3).
The bit is locked in place.
u
Removing a drill bit or screwdriver bit
Grasp the chuck collar (3) and pull away from the front
u
of the tool.