Figure 8-5: Basic - Linksys WVC11B User Manual

Wireless-B Internet Video Camera
Basic
The Basic screen, as shown in Figure 8-5, allows you to alter the Camera's settings, including the network and
wireless configuration.
Device Settings
Firmware Version. The version number of the firmware currently installed is displayed here. Firmware should
only be upgraded from the Help screen if you experience problems with the Camera. Visit www.linksys.com to
find out if there is updated firmware.
MAC Address. The MAC Address of the Camera is displayed here.
Device ID. Displayed here is the Camera's identification name, which is used by the Camera and the Utility to
exchange data.
Camera Name. You may assign any name to the Camera. Unique, memorable names are helpful, especially if you
are using multiple Cameras on the same wireless network. You can enter up to 15 characters.
Description. Enter information about the Camera in this field. You can enter up to 32 characters.

Figure 8-5: Basic

Date. Enter the current date.
Time. Enter the current time.
Time Zone. Select the time zone for the Camera's location.
Network Time Protocol. If you want to adjust the Camera's current time for daylight savings, click the first
checkbox. If you want to update the Camera's time through an NTP (Network Time Protocol) server on the
Internet, click the second checkbox.
LAN Settings
Configuration Type. If the Bridge will obtain an IP address automatically from a DHCP server, then select
Automatic Configuration - DHCP. If you will assign the Camera a static IP address, then select Static IP
Address, and complete the IP Address, Subnet Mask, Gateway, and DNS fields.
IP Address, Subnet Mask, Gateway, Primary DNS, Secondary DNS. Complete these fields if the Camera will
use a static IP address. You need to enter at least one DNS address.
Chapter 8: Using The Wireless-B Internet Video Camera's Web-based Utility 42
Setup