Voice Cables - Cisco VG310 Hardware Installation Manual

Installing the Cisco VG310 and Cisco VG320 Voice Gateways

Voice Cables

Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry tub,
Warning
in a wet basement, or near a swimming pool. Statement 1035
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Warning
Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
Warning
the network interface. Statement 1037
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
Warning
risk of electric shock from lightning. Statement 1038
To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do not
Warning
touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11 port,
or the associated circuit-board when the ringer is active. The ringer is activated by an incoming call.
Statement 1042
For connections outside the building where the equipment is installed, the following ports must be connected
Warning
through an approved network termination unit with integral circuit protection. FXS/T3/E3 Statement 1044
The following table describes the analog FXS voice cables and connections.
Color or Type
RJ-21
OL-31292-01
Connected To
Distribution panel
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide

Voice Cables

Cable
RJ-21-to-RJ-21 straight-through
cable (not included)
45