Table of Contents
Advertisement
Installation instructions
Freestanding gas barbecue with wheels
Freestanding gas barbecue with wheels
It has two fixed wheels and two pivoting wheels with brakes. It acts as a cylinder - holder compartment
but depending on its width can be fitted with drawers or extra compartments.
A cylinder not more than 50 cm tall (with the pressure regulator mounted) can be housed under the
trolley support surface. The pressure regulator outlet should be mounted horizontally.
Assembly and use of the wheels
Screw on the 4 wheels, in the threaded holes under the structure, with the four W1/4" UNC*16 screws
supplied. To stop the barbecue from moving just use the
foot-operated trip lever as shown in the figure. To unlock
the brake, release the lever and allow it to return to the
rest position. Both revolving wheels fitted with a brake
should be fitted on the Right side, while the fixed wheels
should be fitted on the left side, as shown in the section
"Description of the barbecue".
Gas connection
WARNING
Explosion Hazard
Securely tighten all gas connections.
If connected to LP , have a qualified person make sure the gas pressure does not exceed value indicated by
local regulation.
Examples of a qualified person include:
licensed heating personnel, authorized gas company personnel, and authorized service personnel.
Failure to do so can result in explosion, or fire.
If converting to Natural gas, see conversion kit requirements in the "Gas Supply Requirements" section.
Follow intructions included with kit.
Preliminary operations
IMPORTANT: Before installing and using the barbecue you should clean its inner parts to remove any
manufacturing residues. For more information on cleaning refer to "cleaning and maintenance" chapter.
Position the barbecue in an area where complete stability can be assured (see "Installation requirements"
chapter).
Ensure that the wheel brakes are in place as shown on this page ("Assembly and use of the wheels") and
that the barbecue is used on a flat level surface. Always ensure that the appliance is in a perfectly still an
stable position during cooking.
Before using the barbecue, ensure that the white protective film has been removed completely.
Ensure that the white protective film, applied on all visible stainless steel components to protect them
from scratches, has been removed completely.
A protective film has also been applied to the drip tray under the burner assembly of the barbecue. This
should also be removed.
11
Advertisement
Table of Contents
