Beam Mode - Yamaha YSP-800 Owner's Manual

BEAM MODE
You can change the beam mode to suit the input source of this unit using the beam mode buttons on the remote control
(STEREO, 3BEAM, 5BEAM, ST+3BEAM or TARGET). Select stereo mode for 2-channel sources, 3 beam mode, 5
beam mode and stereo plus 3 beam mode for 5. I-channel playback.
All the beam modes are available in the following cases:
• If you selected Parallel to Wall for INSTALLING in AUTO SETUP (see page 30)
• If you selected settings other than CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC
SETUP (see page 59)
• If you selected FLAT TO WALL for INSTALLED POSITION in MANUAL SETUP (see page 65)
Only stereo, stereo plus 3 beam and target modes are available in the following cases:
• If you selected Angle to Wall or corner for INSTALLING in AUTO SETUP (see page 30)
• If you selected CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 59)
• If you selected ANGLE TO WALL OR CORNER for INSTALLED POSITION in MANUAL SETUP (see page 65)
AUTO SETUP BASIC SETUP MANUAL SETUP
....
INSTALLING INSTALLED POSITION
INSTALLED POSITION
(see page 30) (see page 59)
(see page 65)
Beam
mode
CORNER
Parallel to
Angle to Wall
RIGHT
FLAT TO
ANGLE TO
Wall
or Other settings
WALL
WALL OR
or comer
CORNER CORNER
LEFT
STEREO
Yes
Yes
Yes Yes Yes Yes
3BEAM
Yes No No Yes Yes No
5BEAM
Yes No No Yes
Yes No
ST+3BEAM Yes Yes Yes Yes Yes Yes
TARGET
Yes Yes Yes Yes Yes
Yes
Yes: the corresponding beam mode is available.
No: the corresponding beam mode is not available.
40