Makita RP1100 Instruction Manual page 4

ON (Fig.
8
h
9)
ol base on the workpiece to be cut withod
king any contact. Then turn the tool on and
the bit attains
full
speed. Lower the tool
pressing the lock lever down. Release the
at the lowest position and push it hrther to
ool body securely. Move the tool fonvard
workpiece surface, keeping the tool base
advancing smoothly until the culling i s
corn-
ng edge cutling, the workpiece surface
on Ihe left side of the bit in the feed direc-
re that the tool raises automatically when
lever is loosened. The position of the bit
higher
than
the
tool
base when not
operat-
he tool forward
loo
fast may cause a poor
f cut.
or
damage to the bit or motor. Moving
forward too slowly may burn and
mar
the
proper feed rate win depend on the bit size.
d of workpiece and depth of cut. Before
ng the cut on the actual workpiece. i t is
le to make
a
sample cut on a piece of scrap
Thii will show exaclly how the cut will look
as
enable you to check dimensions.
sing the straight guide. be sure to install it
ight side in the feed direction. This will help
it flush with the side
of
the w o r k p b .