For Vigor2860Ac - Draytek Vigor2860 Series Quick Start Quide

1 . 1 . 5 F o r V i g o r 2
1 . 1 . 5 F o r V i g o r 2
LED
ACT (Activity)
USB
2.4G/5G
WAN2
DSL
QoS
WCF
DoS
LED on Connector
Left
WAN2
LED
(Giga)
Right
LED
8 6 0 a c
8 6 0 a c
Status Explanation
Blinking The router is powered on and running
normally.
Off The router is powered off.
On USB device is connected and ready for use.
Blinking The data is transmitting.
On
Wireless access point with bandwidth of
2.4GHz/5GHz is ready.
Blinking
It will blink slowly while wireless traffic
goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
On The router is ready to access Internet
through DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The QoS function is active.
On The Web Content Filter is active. (It is
enabled from Firewall >> General Setup).
On The DoS/DDoS function is active.
Blinking It will blink while detecting an attack.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps
11
Vigor2860 Series Quick Start Guide