Stop Bit Select; Time-Out Between Decodes, Same Symbol - Honeywell 8650 User Manual

Stop Bit Select

The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and prepares
the receiving device for the next character in the serial data stream.
The number of stop bits selected (one or two) depends on the number the receiving computer is programmed to
accommodate. Set the number of stop bits to match host device requirements.
Set this parameter by scanning one of the following bar codes.
* One Stop Bit
Two Stop Bits
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for
different hosts. Contact

Time-out Between Decodes, Same Symbol

Default: 1.0 second
Use this parameter to prevent the beeper from continuously beeping when a symbol is left in the scanner's field of view.
To begin setting differing symbol timeout values, scan this bar code:
Using the Keypad Number Symbols
sent the desired interval, in 0.1 second increments. Valid values are between 0.0 and 9.9 seconds. Single digit values
must be predefined by a leading zero. For example, to set a timeout of 0.5 seconds, scan the Timeout/Decodes – Same
bar code, then scan the number 0 and 5 bar codes.
If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.
Customer Support (page 10-1) for technical help.
(page 4-72) section at the end of this chapter, scan two numeric bar codes that repre-
4 - 23