Editing Port Poe Settings - Motorola WiNG 4.4 Reference Manual

Priority
Limit (watts)
Power (watts)
Voltage (volts)
Current (mA)
Status

3.2.5 Editing Port PoE Settings

To modify the PoE settings for a port:
1. Select a port to edit from the table.
2. Click the Edit button.
The PoE Edit screen shows the port PoE status, Priority, and Power Limit.
3. Check the Enable PoE
uncheck this box.
4. Select the Priority
consumption exceeds the available power. When this happens, ports with higher
precedence over those with a lower
5. Set the Power Limit
amount of power which can be drawn from the selected port.
NOTE: Power limits and power budgets are based on worst case operating conditions to
deliver power at the level requested. The worst case operating conditions assume the
switch is operating at its maximum operating temperature and at a maximum cable
length. As a result power levels may be between 5% and 10.5% over requested level.
6. Click OK to save and add the changes to the running configuration and close the dialog.
Displays the priority mode for each of the PoE ports.
The priority options are:
• Critical
• High
• Low
Displays the power limit in watts for each of the PoE ports. The maximum power limit per
port is 36 watts.
Displays each PoE ports power usage in watts.
Displays each PoE ports voltage usage in volts.
Displays each PoE ports current usage in milliamps.
Displays the operational status for each PoE port. Ports can be either
checkbox to configure the selected port to use Power over Ethernet. To disable PoE on a port,
level for PoE on this port. The
Priority level.
(in watts) for this port's PoE usage. Setting the
Priority level is used in cases where the switch's PoE power
Power Limit
Switch Information 3 - 23
On or Off.
Priority levels will be given
places a cap on the maximum