NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
005954
Installing and removing hook
A) Removal
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
Expand an far end of the hook outward and slide it down
while expanding.
005955
Expand the other far end in the same manner.
005956
Keeping the hook in this position, rotate down to the
angle 90°and remove it by pulling in the direction of
arrow as shown in the figure.
005977
005944
005945
B) Installation
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
Hold both hooking ends in the upper position and
expand the upper part of the hook.
1
005946
Insert both ends, one by one, of the hook into the
grooves in the tool housing.
7
1. Hooking ends