NEC Conference Max Getting Started Manual

P RO G R A M M I N G O P T I O N S
To Access the Programming Menus
Press and hold until appears on the LCD screen.Then press the key that
corresponds with the desired menu option and follow the instructions below.
Menu Option Key Programming
Ringer Melody
1 Press
1-5 to select a new melody. Press
Dialing Mode
2
Press
1 for tone, 2 for pulse. Press
Flash Duration 3 Press
duration. 1 = 600ms, 2 = 300ms, 3 = 150ms, 4 = 100ms, 5 = 80ms.
Press
Local Number*
4 Press
appear on the LCD screen when the phone is in standby.
Press
5 Press
Conference*
Conference key to dial. Press
Service* Press
6
0
key to dial. Press
Country Press
7
desired country. 1 = US/Canada/China/Japan/Mexico/Singapore,
2 = Europe CTR 21, 3 = Australia, 4 = S. Africa, 5 = Brazil, 6 = New Zealand,
7 = South Korea. Press
Press CLEAR once to return to the previous menu level or hold to exit Programming mode
without saving changes.
*Press and hold the "1" key to enter a hyphen or the "*" key to enter a space in the number. If a number has already
been programmed, use CLEAR to delete the old number before entering the new number.
CAUTION: Read the Safety Information in the user manual.
!
© 2005 . All rights reserved. No part of this document may be reproduced in any form or by any means without written
permission from NEC. NEC reserves specific privileges. Information in this document is subject to change without notice.
NEC Conference Max is protected by U.S. Patent No. D499,392 Part No. 800-157-251 (Rev. BETA)
. The current melody selection flashes. Press
to save selection.
. The current dialing selection flashes. Press
to save selection.
. The current duration flashes. Press 1-5 to select
to save selection.
. Enter the phone number that you want to
to save selection.
. Enter the phone number that you want the
to save the number.
. Enter the phone number that you want the
to save the number.
. Press the number key that corresponds with the
to save the country setting.
NEC Conference Max
A u d i o C o n f e r e n c i n g
C O N F E R E N C E P H O N E S E T U P
To Connect NEC Conference Max
1. Connect the Cat. 5 cable from the Link Out jack on the base unit to the Link In
jack on the conferencing pod.
To Link In
25' Cat. 5 cable
To Link Out
2. Connect the base unit to the telephone jack using the RJ-11 telephone cable.
3. Connect the power cord to the base unit and plug the power cord into an
electrical outlet.
To Connect Additional Units
From Link Out
To Link In
25' Cat. 5 cable
To Link Out on Base Unit
1. Connect the 12' Cat. 5 cable to the Link Out jack on the first phone and the
Link In jack on the second phone.
2. Continue linking up to three additional NEC Conference Max phones in the
same fashion. A total of four units may be connected.
Guide
Rear of conferencing pod
RJ-11
Rear of base unit
telephone
cable
12' Cat. 5 cable
To Link In