Setting Up The Radio - Honeywell HX2 Quick Start Manual

1. Connect the HX2 end of the cable to the connector on the bottom of the HX2.
2. Connect the USB type A connector on the I/O cable to a USB port on a PC or
laptop.
ActiveSync starts automatically when the USB cable is connected.
When the HX2 loses connection (e.g., enters Suspend Mode), the connection to
ActiveSync is lost. When the HX2 resumes, disconnect the PC end of the cable and re-
connect.
Please refer to the HX2 Reference Guide for ActiveSync information.

Setting Up the Radio

If the access point uses an authentication protocol (WEP, LEAP, etc.), your radio must
use the same authentication. Please contact your IT department for WEP keys or LEAP
credentials. Please refer to the HX2 Reference Guide for information on using WPA.
1. Tap Start > Programs > Summit > SCU OR tap the Summit Client Utility
icon on the desktop.
2. Tap the Admin Login button and enter the password (default = SUMMIT).
3. Tap the Profile tab and make sure the Default profile is selected.
4. Select SSID and enter your SSID value.
5. If the access point is using WEP, select WEP from the Encryption pull down
list.
6. Tap the WEP keys/PSKs button and enter the WEP Key(s) and tap OK. Skip
to step 12.
7. If the access point is using LEAP, select LEAP from the EAP Type pull down
list.
8. Select WEP EAP from the Encryption pull down list.
9. If the Cisco/CCS certified AP is configured for open authentication, set the
Auth Type radio parameter to Open.
10. If the AP is configured for network EAP only, set the Auth Type radio
parameter to LEAP.
11. Tap the Credentials button and enter the User Name and Password.
12. Tap the Commit button to save the radio configuration.
13. Tap the Main tab. Wait for a radio connected message.
14. Tap the Admin Logout button when finished.
15. Reboot the HX2.