Setting Up The Radio - Honeywell HX3 Quick Start Manual

Setting Up the Radio

If the access point uses an authentication protocol (WEP, LEAP, etc.), your radio must
use the same authentication. Please contact your IT department for WEP keys or LEAP
credentials. Please refer to the HX3 Reference Guide for information on using WPA.
1. Tap Start > Programs > Summit > SCU OR tap the Summit Client Utility
icon on the desktop.
2. Tap the Admin Login button and enter the password (default = SUMMIT).
3. Tap the Profile tab and make sure the Default profile is selected.
4. Select SSID and enter your SSID value.
5. If the access point is using WEP, select WEP from the Encryption pull down
list.
6. Tap the WEP keys/PSKs button and enter the WEP Key(s) and tap OK. Skip
to step 12.
7. If the access point is using LEAP, select LEAP from the EAP Type pull down
list.
8. Select WEP EAP from the Encryption pull down list.
9. If the Cisco/CCS certified AP is configured for open authentication, set the
Auth Type radio parameter to Open.
10. If the AP is configured for network EAP only, set the Auth Type radio
parameter to LEAP.
11. Tap the Credentials button and enter the User Name and Password.
12. Tap the Commit button to save the radio configuration.
13. Tap the Main tab. Wait for a radio connected message.
14. Tap the Admin Logout button when finished.
15. Reboot the HX3.
Please refer to the Radio Mode parameter in the HX3 Reference Guide. It is important
that this parameter setting corresponds to the Access Point to which the HX3
connects.