Table of Contents
Advertisement
13. A Logon window will appear, requiring you to enter a User name and
Password. Make up a user name and password (if you haven't already) and
click the OK button. Do not click the Cancel button or press the Escape
key. Clicking either of these buttons will prevent you from logging into the
network. If the logon does not appear or if it does not allow you to log on,
refer to the Troubleshooting section.
14. Once you are at the Windows 98 desktop, double-click on the Network
Neighborhood icon. You should see one icon for the entire network and the
names of the other PCs on the network.
If you can see your computer along with all the other computers on the
network in Network Neighborhood, then the Windows 98 network config-
uration is complete. Continue with Appendix B: Sharing Your Files and
Printers if you want your PC's data or printer to be available to others on
the network. You may stop here, however, if you wish to configure File and
Printer Sharing at a later time.
Refer to the Troubleshooting section if:
• You don't see anything at all in Network Neighborhood and have pressed
the F5 key on your keyboard a few times to refresh the screen.
• You only see your own computer in Network Neighborhood.
• You see all computers on the network except yours and have tried press-
ing the F5 key a few times.
• You only see computers that are running the same operating system as you
and you don't see any others.
27
Instant EtherFast
®
Series
EtherFast
®
10/100 LAN Card
Chapter 7: Manual Installation and
Setup for Windows ME
Overview
After physically installing the EtherFast
follow these instructions to install the network device driver. If at any time dur-
ing the installation you encounter problems, consult the Troubleshooting sec-
tion.
Installing the Network Card's Driver
1. Start up your PC in Windows ME.
2. Windows ME will automatically detect the presence of the PCI Ethernet
Controller hardware in your PC.
3. Insert the Linksys LNE100TX
(ver. 5) 10/100 LAN Card Setup
Utility CD into your CD-ROM
drive while the Add New
Hardware Wizard window is
visible. Click the Next button.
4. Click the Specify the location of the driver (Advanced) radio button. Click
the Next button.
®
10/100 LAN Card in your computer,
28
Advertisement
Table of Contents
