Functional Description; Assembly; Switch Action; Adjusting The Orbital Stroke Rate - Makita TM3010C Instruction Manual

FUNCTIONAL DESCRIPTION

WARNING:
Always be sure that the tool is switched off
•
and unplugged before adjusting or checking
function on the tool. Failure to switch off and
unplug the tool may result in serious personal
injury from accidental start-up.

Switch action

013899
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
To start the tool, slide the slide switch toward the "I
(ON)" position.
To stop the tool, slide the slide switch toward the "O
(OFF)" position.

Adjusting the orbital stroke rate

012852
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 5. The
higher the number is, the higher the orbital stroke rate is.
Preset the dial to the number suitable for your
workpiece.
NOTE:
The dial cannot be turned directly from 1 to 5 or
•
from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke
rate is kept constant even under load condition.
1. Slide switch
1
1. Dial
1

ASSEMBLY

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing application tool
(optional accessory)
WARNING:
Do not install application tool upside down.
•
Installing application tool upside down may
damage the tool and cause serious personal injury.
Install attachment tool in the correct direction
•
according to your work. Application tool can be
installed at an angle of every 30 degree.
CAUTION:
Be careful when closing the lock lever. The lock
•
lever may close suddenly and pinch your finger.
Clean up dust and perform lubrication on the
•
moving part of the lock lever from time to time.
Otherwise dust may accumulate in the moving part
of the lock lever and hinder its smooth movement.
Do not start the tool while the lever opens. The
•
tool may be damaged.
2
013898
1. Open the lock lever fully. And remove the holder
bolt.
3
013853
2. Put an application tool (optional accessory) on
the tool flange so that the protrusions of the tool
flange fit in the holes in the application tool.
6
1. Holder bolt
2. Lock lever
1
1. Holder bolt
2. Holes in the
2
application tool
1
3. Protrusions of
the tool flange