System Clock Setup By Station Dialing; Day/Night Mode Change By Station Dialing - NEC UNIVERGE DT830G(DG) User Manual

SYSTEM CLOCK SETUP BY
STATION DIALING
This feature enables a terminal user to adjust the
system clock.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator.
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial System Clock Setup access
code or press System Clock Setup
feature key.
You will receive a feature dial tone.
11:00 AM SUN 1 JUN 2014
Recall PICK
3. Dial new time in 24 hr. format using
6 digits (HHMMSS).
You will receive a service set tone.
4. Press Speaker key.
Speaker key lamp goes off. →
>>>>
110000
104
DAY/NIGHT MODE
CHANGE BY STATION
DIALING
This feature allows selected terminals to activate a
change from day mode to night mode by dialing a
special code.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator.
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial Day/Night Mode Change access
code or press Day/Night Mode
Change feature key.
11:00 AM SUN 1 JUN 2014
Recall PICK
FEATURE OPERATION
DAY
>>>>