Indoor unit installation
AA
pipe and hose pass to connect the indoor unit to the outdoor unit.
1. Determine the position of the pipe and drain hose hole as seen in the picture and drill the hole with an inner diameter
of 65mm so that it slants slightly downwards.
Pipe hole
(Ø
B
2. Fix the indoor unit.
If you fix the indoor unit on a wall
between the wall and the plate, created by projected anchor, is less than 20mm.
If you fix the indoor unit on a window frame
attached to the window frame.
attention to the weight of the indoor unit.
tapping screws.
plate hanger.
strong enough to withstand the product weight, the unit could fall and cause injury.
Purging the indoor unit
Nitrogen gas is not injected into this product.
1. Unscrew the caps at the end of each pipe.
Direction of pipe
A
D
D
C
Model
052/071
C
B
A
B
C
D
27 120
27
34 140
34
If you fix the indoor unit on a gypsum board
Pipes
hole after choosing the
direction of the pipe.
Plastic
<20mm
7