Changing Direction Of The Drain Hose; Fixing The Indoor Unit In Place - Samsung AC444FBRDEH Installation Manual

Changing direction of the drain hose

AA
Change the direction only when it is necessary.
1. Detach the rubber cap with the plier.
2. Detach the drain hose by pulling it and turning to the left.
3. Insert the drain hose by fixing it with the screw into the groove of the drain
hose and the outlet of the drain pan.
4. Attach the rubber cap with a screwdriver by turning it to the right until it
fixes to the end of the groove.
5. Check for leakage on both side of the drain outlet.
Pour the water in direction of arrow.

Fixing the indoor unit in place

Perform the following work on the area where gas leak test was done priorly.
Then place the indoor unit on the installation plate.
1. To avoid condensation problems, wrap foam insulation (as shown in the figure) on a
part without insulation on the end of the pipes.
2. Wind the pipe, assembly cable and drain hose with vinyl tape.
3. Place the bundle (the pipe, assembly cable and drain hose) in the lower part of
the indoor unit carefully so it does not project from the rear of the indoor unit.
4. Hook the indoor unit to the installation plate and move the unit to the right and
left until it is securely in place.
an installation plate.
5. Wrap the rest of the pipe with vinyl tape.
6. Attach the pipe to the wall using clamps (optional).
Direction of the drained water
Screw hole
Drain hose
Drain pan outlet
Insulation
Pipes
Installation
plate
Connecting wires
Drain hose
Screw
Connecting
pipes
11