Table of Contents
Advertisement
Our units should be installed in compliance with the spaces shown in the installation manual, to ensure accessibility from both
disassemble without endangering people and objects.
For this reason, when provisions of the installation manual are not complied with, the cost required to access and repair the units
Power supply line, fuse or circuit breaker
with current local safety standards.
to ensure the operation of any other domestic appliance connected to the same electric lines.
included in the manual.
to the installation of air conditioners.
Devices disconnected from the power supply should be completely disconnected in the condition of overvoltage category.
complete, electric shock or fire may occur.
Install the circuit breaker.
Install the power cable and communication cable of the indoor and outdoor unit at least 1m away from the electric appliance.
Install the indoor unit away from lighting apparatus using the ballast.
Do not install the air conditioner in following places.
leak. The capacity of the heat exchanger may reduce or the air conditioner may be out of order.
The copper pipe or connection pipe may corrode and refrigerant may leak.
normally due to control system.
Preparation for installation
General
Do NOT install the air conditioner in a location where it will come into contact with the following elements :
Combustible gases
Saline air
Sulphide gas
Special environmental conditions
If you must install the unit in such conditions, first consult your dealer.
Avoid installing the air conditioner :
In areas where it is exposed to direct sunlight. Close to heat sources.
In areas where curtains and furniture could affect the supply and discharge of air.
In scarcely ventilated areas.
On surfaces that are unable to support the weight of the unit without deforming, breaking or causing vibrations
during the use of the air conditioner.
In a position that does not enable the condensate drainage pipe to be correctly installed. (at the end of the
3
Advertisement
Table of Contents
