Advertisement
MAINTENANCE
CAUTION
:
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
Adjusting for accuracy
of
90" cut (vertical cut)
This adjustment has been made
a t
the factory. But if it is off, adjust the adjusting screw
with
a
screwdriver while squaring the blade with the base using
a
triangular rule, try-
square,
etc.
7
rBase
(-1
Screw
Fig. 16
Fig. 1
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down to
the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced
a t
the
same time. Use only identical carbon
brushes.
Fig. 18
Use
a
screwdriver to remove the brush
holder caps. Take out the worn carbon
brushes, insert the new ones and secure the
brush holder caps.
/
-Screwdriver
: B
r u
s h
holder cap
Fig. 19
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
12
Advertisement
