Speakers Set - Yamaha RX-V795a Service Manual

RX-V795a/RDS/HTR-5170

(5) SPEAKERS SET

The input is automatically discriminated by AC3>DTS>PCM>analog. The L/R signals are output to the channels
specified by the submenu without being processed (through).
There are the following 9 submenu items: The signal from the DSP block is normally in the effect off status for menu
items 1-4. For other menu items, the same signal as in 2. DSP THROUGH: YSS918 menu is output.
5.MAIN:SML 0dB
5.B:M&C:NONE
5.CENTER:NONE
The analog switches in each submenu are set as follows:
SUB MENU
1 MAIN:SML 0dB
2 MAIN:LRG 0dB
3 MAIN:LRG -10
4 B:M&C:NONE
5 BASS:MAIN
6 LFE/BASS:SWFR
7 CENTER:NONE
8 C:SML&R:SML
9 FRONT MIX
LARGE: Mode in which speakers with high bass-sound playback capability (large unit) are used. Full frequency band
widths is output.
SMALL : Mode in which speakers with low bass-sound playback capability (small unit) are used. Frequencies below 90 Hz
are mixed with the channel specified by LFE/BASS.
NONE : Mode in which center speaker is not used. The center audio signal is reduced by 3dB and mixed into MAIN L/R.
M : MAIN
C : CENTER
R : REAR
SWFR : SUBWOOFER
B : BASS
Output : The signal before MASTER VOLUME is indicated.
15
5.MAIN:LRG 0dB
5.BASS:MAIN
5.C:SML&R:SML
REMOTE
CENTER SP REAR SP
CODE
7A-8B LARGE LARGE
7A-8C LARGE LARGE
7A-8D LARGE LARGE
7A-8E NONE LARGE
7A-8F LARGE LARGE
7A-90 LARGE LARGE
7A-91 NONE LARGE
– – – SMALL SMALL
7A-85 LARGE LARGE
5.MAIN:LRG -10
5.BASS:SW
5.FRONT MIX
MAIN SP MAIN LVL LFE/BASS
SMALL 0dB SWFR
LARGE 0dB SWFR
LARGE -10dB SWFR
LARGE 0dB MAIN
LARGE 0dB MAIN
LARGE 0dB SWFR
LARGE 0dB SWFR
LARGE 0dB SWFR
LARGE 0dB SWFR
OUTPUT
MAIN L/R
MAIN L/R
MAIN L/R
MAIN L/R
LFE -> L/R
LFE -> SWFR
CENTER -> L/R
CENTER/REAR
FRONT -> L/R