Operation And Display When Starting Diagnosis Function; Selection Of Diagnostic Menu; Other Functions Available While Diagnosis Function Is Active; Diagnosis Default Status - Yamaha RX-V795a Service Manual

RX-V795a/RDS/HTR-5170

3. OPERATION AND DISPLAY WHEN STARTING DIAGNOSIS FUNCTION

(1) Selection of diagnostic menu

The diagnostic menu and the sub-menu can be selected by using the front panel keys of the main unit or the remote
control unit.
Selection by using the front panel keys
The main menu can be changed cyclically by using the "TUNING UP/DOWN" keys; and the submenu, by using the
"PROGRAM -/+" keys. The "+" or "UP" key will increase the main or submenu number.
Selection by using the remote control unit
The remote control codes in the menu list (on
page 8) correspond to the DSP program, test and
effect keys. See the figure on the right.
(2) Display during Menu Operation
During diagnosis function, the diagnostic menu will appear on the superimposed screen, except for main menu No. 6.
As a rule, the main menu No. and submenu No. will appear in the FL display.

(3) Other functions available while diagnosis function is active

Listed below are the other functions available while the diagnosis function is active.
• Selecting input source (Tape monitor/Ext. decoder)
• Adjusting effect level (Center, Rear, Sub-woofer)
• Adjusting master volume
• Muting on/ off
• Tuning power off

(4) Diagnosis default status

When not otherwise specified, default settings and values in each menu are as follows:
All "SPEAKERS" : LARGE
ALL electronic VRs : 0dB
D-RANGE : MAX
LFE LEVEL : 0dB
CENTER DELAY : 0ms
11
DD/DTS
MOVIE
SURROUND
THEATER 2
MOVIE
THEATER 1
MONO
DISCO
MOVIE
TV
SPORTS
ROCK
CHURCH
CONCERT
JAZZ CLUB
HALL TEST
EFFECT