Cisco ATA 186 User Manual page 3

About the Cisco ATA 186
Additional Feature
Cisco ATA 186 Installation and Configuration Guide
1-3
Dual RJ-11 Ports
•
– Supports two independent RJ-11 telephone ports that can connect to any
standard analog telephone device. Each port supports either voice calls
or FAX sessions, so that the user can talk on one port while sending a
FAX on the other.
There are two RJ-11 FXS port terminating impedance options, 600 Ohms
–
resistive or 270 Ohms + 750 Ohms // 150 nF complex impedance. The
impedance of the Cisco ATA 186 depends on the option ordered and must
match the particular application. If you are not sure of the applicable
configuration, check the country or regional telephone impedance
requirements.
Indicators
•
– Function Button
The Cisco ATA 186 function button is located in the top panel of the
device. The function button lights when you pick up the handset of a
telephone attached to the Cisco ATA 186. When the function button
blinks, the device is in configuration search or upgrade mode. You also
use the function button to access the interactive voice response (IVR)
configuration menu. To configure the Cisco ATA 186 by using the IVR
mode, see Chapter 3, "Configuring the Cisco ATA 186."
Activity LED
–
The green Activity LED located on the back panel flashes to indicate
network activity.
5 Volt power adapter connector (adapter included)
•
10Base-T Ethernet port
•
Supports polarity reversal before and after caller-ID signal.
Chapter 1 Cisco ATA 186 Overview
OL-1267-01