Plumbing; Ro System With Storage Tank - Honeywell 50045947-001/011 Operating Instructions Manual

RO System with
Storage Tank
(Model 50045947-001 / 011)
Drain Points for Reject Water
Follow local codes for proper installation
Refer to additional drain requirements in steam
humidifier manual when coupling RO drain and
humidifier drain
Sump
air
gap
Standpipe
air gap
air
gap
Condensate Floor
Pump Drain
Cut 1/4" dia. tubing lines to fit your installation.
Ensure all cuts are evenly made with no nicks,
scratches or rough spots on the tube end.
Longer tubing lengths – nylon or copper – may
also be used (not provided). Ends of tubing
must be round and free of burrs and scratches
to seal properly.
Install 3/8" x 1/4" adapter elbow into blue outlet
port.
Install 3/8" dia. yellow tube between yellow inlet
port and storage tank valve.
Locate drain line assembly (1/4" dia. red tubes
assembled to flow control coupling). Install 1 ft.
long end of 1/4" dia. red drain line into red port
in the RO system. Route the longer 1/4" dia.
red drain line to a drain. Note that the coupling
contains a flow control that is critical to the
function of the RO system. Make sure the
drain line assembly is installed correctly.

PLUMBING

Cold Water
Supply
Red Tubing
air
gap
air
gap
Laundry Floor
Tub Drain
To Steam
Shutoff
Humidifier Control Valve
1/4" White
Tubing
1/4"
#1 #2
Drain Flow
Control
Push tubing completely into applicable fitting by
pushing past initial resistance and then applying
light pulling force to ensure a tight fit.
Tubing Collar
Tube Fully Engaged with Fitting
– To remove tube from connection, depress
collar and pull tubing.
Collar (depress to
remove tubing)
Tubing
Water tube connections to the water supply, fil-
ter and steam humidifier must be checked for
leaks after installation and a short period of
operation.
5
1/4" White
Tubing
3/8" x 1/4"
Adapter Elbow
Closed Open
3/8"
Yellow Tubing
#3
Storage Tank
FIG. 3
O-Ring
FIG. 4
FIG. 5