Black & Decker CD400A-XE Manual page 7

Carefully unpack all parts.
Please note that additional items may be found
in the carton, depending on the letter suffix
following the catalogue number of your tool.
OVERVIEW (fig. A)
1. On/off switch
2. Dust extraction outlet
3. Sanding base
4. Paper clamp lever
5. Variable speed control knob (KA196E-XE)
ASSEMBLY
Before assembly, make sure that the tool
is switched off and unplugged.
Fitting sanding sheets (fig. B, C & D)
Never use the tool without a sanding
sheet or accessory in place.
KA196-XE/KA196E-XE-
Make sure that the tool is switched off and
unplugged.
Press the sheet firmly and evenly onto the
sanding base (3), making sure that the holes in
the sheet line up with the holes in the base.
CD400A-XE/KA196-XE/KA196E-XE-
Fitting regular sanding sheets
Make sure that the tool is switched off and
unplugged.
Soften the sanding sheet by rubbing its non-
abrasive side over the edge of a worktop.
Press the paper clamp levers (4) upwards to
release them from the retaining grooves and
open the paper clamps by pressing them down.
Place the sheet onto the sanding base, making
sure that the holes in the sheet line up with the
holes in the base.
Insert the edge of the sanding sheet into the
front paper clamp as shown.
Press the front paper clamp lever (4) downwards
and locate it in the retaining groove.
While keeping a slight tension on the sheet,
insert the rear edge of the sheet into the rear
paper clamp.
Press the rear paper clamp lever (4) downwards
and locate it in the retaining groove.
KA273-XE-
Make sure that the tool is switched off and
unplugged.
Soften the sanding sheet by rubbing its non-
abrasive side over the edge of a worktop.
Operate the paper clamp levers (4) as shown
to open the paper clamps.
Place the sheet onto the sanding base, making
sure that the holes in the sheet line up with the
holes in the base.
Insert the edge of the sanding sheet into the
front paper clamp as shown.
Operate the front paper clamp lever (4)
to close the front paper clamp.
While keeping a slight tension on the sheet,
insert the rear edge of the sheet into the rear
paper clamp.
Operate the rear paper clamp lever (4) to close
the rear paper clamp.
CD400A-XE/KA196-XE/KA196E-XE-
Connecting a vacuum cleaner (fig. E)
Insert the adaptor (6) into the dust extraction
outlet (2).
Connect the hose (7) of the vacuum cleaner to
the adaptor.
KA273-XE -
Fitting and removing the dustbag (fig. F)
To fit the dustbag, slide the cover (8) of the
dust extraction outlet backward.
Insert the nozzle (9) on the dustbag (10) into
the outlet (2) until it is properly located.
To remove the dustbag, depress the release
catch (11) and pull the dustbag upwards off
the outlet.
USE
Let the tool work at its own pace.
Do not overload.
E N G L I S H
7