Cleaning The Spray Arms; Cleaning The Control Panel - Baumatic BYDI630 User Manual

IMPORTANT: If a glass gets smashed inside of the appliance,
you must check there is no glass in the filter before the
machine is used again as this can cause a drainage failure.
IMPORTANT: THE DISHWASHER SHOULD NEVER BE
SET ON A WASH CYCLE WITHOUT THE FILTERS BEING
INSIDE OF THE APPLIANCE.

Cleaning the spray arms

The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
o To remove the spray arm, unscrew the nut and take out the
washer that sits on top of the spray arm.
o Gently pull upwards to remove the spray arm.
o Wash the spray arm in warm, soapy water and use a soft brush
to clean the jets.
o Rinse the spray arm thoroughly and then reassemble the spray
arm back in its original position.

Cleaning the control panel

IMPORTANT: Do not use any abrasive cleaner or household polish on
either the control panel or operating parts.
o Wipe over the control panel using a brand new damp cloth with
warm water.
26