Fault Codes (T 1576 Only); Table 6-2: Service Mode Functions (T 1576) - Miele T 15xx Technical Information

T 15xx Dryers
6.1.2 T 1576
Accessing:
1. Switch the appliance off.
2. Turn the program selector switch to 12 o’'clock.
3. Press and hold the Gentle and Start buttons.
4. Switch the appliance on.
5. Release the buttons.
Acknowledgement indicator:
The “"Drying”" LED flashes to show that service mode is activated.
Navigation:
Refer to Table 6-2. Turn the program selector switch to the desired position, then
press Start.
To exit the service mode, switch the appliance off.
Selector Switch Position
COTTONS Extra dry
COTTONS Normal +
COTTONS Normal
COTTONS Hand iron
COTTONS Hand iron
COTTONS Rotary iron
Fluff
20 mins.
Line Dry
Woolens
PERMA PRESS Hand iron
PERMA PRESS Normal
PERMA PRESS Normal +

Table 6-2: Service Mode Functions (T 1576)

6.2

Fault Codes (T 1576 Only)

Initial requirements:
1. Switch the appliance on.
2. Turn the selector switch to the “"COTTONS Extra dry”" position.
3. Press the Start button to begin the program.
4. Note the status of the “"Anti-crease”" LED:
The “"Anti-crease”" LED is lit STEADILY - No faults stored.
Press Start to Activate...
Main motor operates 10 seconds in each direction
Vacant
One heater and main motor operate
Main motor operates
Both heaters and main motor operate
“"Cooling down”" lights up = OK
Residual moisture
sensor test
“"Cooling down”" flashes = fault
“"Cooling down”" lights up = OK
Residual moisture
sensor test
“"Cooling down”" flashes = fault
LED test
Button test
Fault codes (see Section 6.2)
Vacant
Vacant
Vacant
37
Technical Information