Program Option Buttons –- T 1576; Condensed-Water Drawer (Condenser Models Only); Heat Exchanger (Condenser Models Only) - Miele T 15xx Technical Information

T 15xx Dryers
3.4 Program Option Buttons – T 1576
Low Energy (with Cottons Program)
Normal heater operation with a lower temperature.
Turbo (with Cottons Program)
Normal heater operation with a higher temperature.
Gentle
Uses a lower temperature and extended program time for care of delicate fabrics.
Buzzer
Enables the buzzer when the anti-crease stage of the program is reached.
3.5

Condensed-Water Drawer (Condenser Models Only)

General information:
Depending on the installation, condensed water is either pumped to an on-site
drain or collected in the condensed-water drawer.
The condensed-water drawer holds approximately one gallon of water. The water
should be emptied from the drawer after each program completes. Should the
container be full (or become filled during operation), the following occurs:
The “"Empty out container”" LED lights up
The buzzer sounds
The drying program stops and enters the cooldown cycle
To empty the condensed-water drawer:
1. Hold the cap open while emptying the water drawer.
2. Drain all water.
3. Install the water drawer back into the appliance. Ensure that it locks into place.
Warning!
The condenser water is not suitable for drinking.
3.6

Heat Exchanger (Condenser Models Only)

Note:
The heat exchanger should be cleaned at least twice a year.
1. Open the door. Locate the heat exchanger cover at the bottom left of the
appliance.
2. Turn the lever so that it is in a vertical position (refer to Figure 3-1).
15
Technical Information