Handling Rubber Feet - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Basic hardware procedures
4.10

Handling rubber feet

Figure 33: Handling the rubber feet
Removing rubber feet
Ê Lay the server on its right-hand side.
I
At least two people are needed to turn over a fully equipped server.
Remove hard disk drives and power supply modules in order to
facilitate the task.
Ê Using a slotted screw driver, slightly pry up on each rubber foot until it
detaches.
Installing rubber feet
Ê Push in each rubber foot.
Ê Bring the server back to its vertical position.
76 Upgrade and Maintenance Manual
TX2540 M1