Advertisement
2
4
1
3
013344
Insert screwdriver into the hole in the inner flange. Grip
the hex nut with the wrench, turning in the direction of
wheel rotation to loosen the hex nut. Remove the hex
nut, outer flange and sleeve. Then install the wheel,
outer flange and hex nut. The sleeve is only used during
shipment. Discard it at this time.
Tighten the hex nut in the direction opposite of the
wheel rotation.
OPERATION
CAUTION:
Apply light pressure on the tool. Excessive
•
pressure on the tool will only cause a poor finish
and overloading of the motor.
The grinding wheel continues to rotate after the
•
tool is switched off.
Hanger
013347
Continuous operation of the grinder is made easy by
using the handy hanger as shown in the figure. Simply
loop the cord over the head or shoulder, after threading
it through the eyelet on the top of the tool housing.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
1. Hex nut
5
2. Outer flange
3. Grinding wheel
4. Sleeve
5. Inner flange
6. Spindle
6
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1
013343
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
6
1. Limit mark
1
1. Brush holder
cap
2
2. Screwdriver
Advertisement
